About four years ago our company bought a DSC installer code breaker at
the
ISC show in Anaheim, California.
It is called a SEMCO 10-8 Programer
It is a simple looking device that attaches to the keypad wiring of the
control
It has a red & green led, the red led flashes as it is decoding and the
green led lights steady when the process is finished.
To activate you apply power and press into keypad *8 20 for 1500-1550
panels *8 18 for 2500, *8 24 for 2550 and 3000 panels
It works by trying all possible combination one at a time, and when it
cracks the code it changes it to 0123
It is not practical to use it in the field, because it can take up to 3
hours to decode one unit, depending on how high the installer code was
for
that panel.
Our problem is there is no address or phone numbers on the instruction
sheet, we can't find the manufacture
A note at the bottom says contact your SEMCO distributor for any known
version changes.
http://forums.cabling-design.com/security-physical/dsc-installer-code-cracker-21581-.htm
the
ISC show in Anaheim, California.
It is called a SEMCO 10-8 Programer
It is a simple looking device that attaches to the keypad wiring of the
control
It has a red & green led, the red led flashes as it is decoding and the
green led lights steady when the process is finished.
To activate you apply power and press into keypad *8 20 for 1500-1550
panels *8 18 for 2500, *8 24 for 2550 and 3000 panels
It works by trying all possible combination one at a time, and when it
cracks the code it changes it to 0123
It is not practical to use it in the field, because it can take up to 3
hours to decode one unit, depending on how high the installer code was
for
that panel.
Our problem is there is no address or phone numbers on the instruction
sheet, we can't find the manufacture
A note at the bottom says contact your SEMCO distributor for any known
version changes.
http://forums.cabling-design.com/security-physical/dsc-installer-code-cracker-21581-.htm
Ultra Fast Programming Speed SuperPro 610P is designed with high programming speed in mind. Our semiconductor manufacturer approved algorithms, precision and clean signals guarantee high programming yield. Special design was made to eliminate overshoot and ground bounce. Algorithms are performed with state machine architecture constructed with FPGA to achieve a ultra-high programming speed. | |
Tester for Logic Devices and SRAMs SuperPro 610P is also designed for IC testing of various devices such as TTL, CMOS Logic(74/4000 series), and SRAM memory devices . http://www.xeltek.com/universal-programmers/superpro-610p-universal-ic-chip-device-programmer/ |
No comments:
Post a Comment